How to replace car fob battery

Ways to Recondition a Cars And Truck Battery

Don’t quit on your vehicle battery right now; there’s a strategy that has the ability to repair your cars and truck battery and make it usable again.


Exactly what if I told you …

You could simply keep the very same battery, restore it, and conserve lots of cash?

Luckily, you can with a process called battery reconditioning. How to replace car fob battery

There are secrets which Tom Exposes here, but will discuss the fundamentals of how to recondition your car battery.

Here’s a secret video on the best ways to recondition your car battery from Tom.

ez battery reconditioning

If you didn’t check out the secrets, then pay close attention and discover how to revivify your battery.

Here’s the following actions:

  1. Shut off your automobile – allow cooling to happen for roughly an hour
  2. Raise hood, then separate the battery( utilize a wrench to detach the unfavorable wire before the favorable one).
  3. Careful to ensure that your wrench is not touching any other metal parts or electrical shock can happen.
  4. After detaching wires, get rid of the battery from the cars and truck.
  5. Now, remove the plastic caps that are on top of the battery cells. Below, you will see where the cells have been sealed.
  6. Run a power drill to make a hole in these marks( cover eyes with googles).
  7. Equip gloves, turn battery upside down and remove contents of the cell.
  8. Slowly add small amounts of baking soda to the container. This neutralizes the liquid.
  9. Repeat the action above for all cells.
  10. Now, blend one part Epsom salt into 3 parts of warm, distilled water.
  11. There need to be a quart of this solution for one cell.
    Pour the service onto the cells, shake it around for a bit and let it sit.How to replace car fob battery

Here’s how you end up the job:.

Reconnect the 3 phase charger to the battery.
Guarantee that the battery is off– link the positive wire first and then the negative wire.
Set the battery charger to 12 Volts and change it on. Let charge for 12 hours.
Cover the drilled holes with replacement plugs and put the battery back into the hood and link it to the cables positive first).
Congrats, you simply conserved and revived your battery!

Here is a video to help you understand the process better:.

ez battery reconditioning

An alternative way to restore your car battery is with Epsom salt: